Mcmurdo NAV6 Guía de usuario descargar pdf (Pagina 29)

Nav6 Plus Navtex System User Guide

Set the filter for each station to one of the following:

Setting Notes

On Messages from station always printed

Off Messages from station never printed

Auto Messages from station printed only when nearest or in

range depending upon setting.

Setup Mode, Navtex View, 518 and 490 Names Pages

Setup Mode, Navtex View, 518 and 490 Names PagesSetup Mode, Navtex View, 518 and 490 Names Pages

Setup Mode, Navtex View, 518 and 490 Names Pages

The station names setup pages

determine the names of stations

displayed on station filter pages and

in Navtex message headers.

The picture shows the ‘518 Names’

page; the ‘490 Names’ page is

similar.

Use the

UP and DOWN keys to

select the setting that you wish to

edit. Use the

LEFT and RIGHT keys

to change the setting.

The Station Name Selection setting allows the user to select

between ‘GPS’ and ‘Manual’ station selection. If ‘GPS’ is selected

and there is valid position data on the NMEA input, the Nav6 will

select the NAVTEX transmitting station name nearest to the boat’s

current location for each station letter.

If ‘Manual’ is selected, then the user can manually select the

transmitting station name to be displayed for each station letter.

(Tip : You may be sailing in Nav Area II and therefore will pick station

names from Nav Area II. However it is important to realise that the

corresponding station letter in the adjacent Nav Areas may be

closer. For example, the ‘S’ station that you are receiving is the ‘S’

station in an adjacent Nav Area).

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 59 60

Sin comentarios

Mcmurdo NAV6 Guía de usuario Pagina 29